氣體增壓泵故障及其處理方法

氣體增壓泵故障及其處理方法1泵不工作：

1 pump does not work:

a.檢查驅動氣源是否開啟，驅動壓力是否滿足要求；

A. check the drive source is turned on, the driving pressure whether meet the requirements;

正常空氣增壓泵的進氣壓力要求3-8bar,泵長期不工作，應先向驅動氣口內噴少量潤滑油，最好為硅油，然后驅動氣壓盡量調高，待泵正常運行幾分鐘后，再裝氣壓調至所需壓力，新泵裝配過程中，都會在換向閥內涂一層潤滑脂，長期不用時，潤滑脂會凝固。

The normal air intake pressure booster pump for 3-8bar, the pump does not work, should first to drive air outlet in spray a small amount of lubricating oil, preferably silicone oil, then driven pressure to increase, to pump the normal operation after a few minutes, and then loaded pressure adjusted to the required pressure, the new pump assembly process, will be in the reversing valve coated with a layer of grease, not a long time, will be solidified lubricating grease.

c. 檢查換向閥氣路是否暢通；

C. check valve gas path is smooth;

2.泵動作突然加快，驅動活塞不到頭就換向：

2 pump action suddenly accelerate, driving the piston does not end on reversing:

a. 撞針漏氣。

A. striker leakage.

長期使用，尤其無油潤滑的情況下，可能會出面撞針前后腔串氣，致使撞針密封不好，換向閥工作不正常，泵頻率加快。

The long-term use, especially non oil lubricating condition, may step in to a cavity mixes up, resulting in the firing pin seal is not good, the reversing valve is not working properly, the pump speed.

---

當前位置： 首頁 >> 公司動態 >> 行業資訊 發布時間： 2014-08-05
上一篇： 氣密性檢測裝置設備配置  下一篇： 氣體增壓泵應用范圍